EUPBWB031 is a high-density crimped Xtreme-wire wheel brush for stationary table-deburring machines. It is designed for end-face and edge deburring of tubes, profiles and flat parts, with adjustable immersion depth to follow complex component contours.
| Family code | EUPBWB031 |
|---|---|
| Tool | Crimped Xtreme-wire wheel brush |
| Machine | Stationary table-deburring machine |
| Applications | Tube ends, profiles and flat-part edges |
| Example diameter | 250 mm |
| Example face width | 60 mm |
| Example trim length | 53 mm |
| Example fill | Steel wire, 0.30 mm |
| Example arbor hole | 50.8 mm |
| Maximum speed | 3,600 rpm |
| Example SKU | 3902-576175 |
The wheel brush targets inner and outer edges at pipe ends as well as edges on profiles and flat parts. A dense wire pack supports high deburring output and long service life.
Adjustable immersion depth lets the trim engage changes in component contour without using excessive brush penetration.
The family uses crimped Xtreme wire in a stationary-machine format. One documented configuration has a 250 mm diameter, 60 mm face width and 53 mm trim length.
The cited fill is 0.30 mm steel wire, with a 50.8 mm arbor hole.
The documented maximum speed is 3,600 rpm. The displayed variant is made to order and carries SKU 3902-576175.
Bore fit, keying, rotation direction, guard clearance and the lower of machine or brush speed ratings must be verified before installation.
Set immersion only deep enough for the wire tips to work the burr; forcing the wheel increases heat, bending stress and wire fatigue.
Validate edge condition, feed rate, part support and finish on representative parts, then monitor brush diameter and balance as the trim wears.
POLISHX technical profile ยท 2026-10-11 20:34:50