POLISHX

GILOX-Series | Almatis

The Almatis GILOX family comprises mechanically strong, coarse polishing aluminas intended for high cutting rates, grinding and pre-polishing. The range combines primary particles up to 25 µm with controlled friability and includes GILOX 63, P 20 and PBC grades for different preparation routes and cutting intensity.

MaterialAlumina
Primary particle sizeUp to 25 µm
Process positionGrinding and pre-polishing
GILOX 63Ground P 25; 63 µm top cut
P 20Plate-like primary crystals around 20 µm; requires further processing
PBCHighly abrasive grade for high cut
Sintered base gradesT60/T64
Key controlGrade-specific grain friability

Series design

GILOX grades are based on mechanically strong alumina crystals that can be classified into different size bands without excessive crystal breakdown. The series is positioned where rapid removal and surface preparation are more important than the final gloss stage.

Particle structure, top cut and friability govern how aggressively a grade fractures and renews its cutting edges during use. These variables should be evaluated together rather than selecting on nominal size alone.

Grade map

GILOX 63Ground version of P 25 with a 63 µm top cut
P 20Plate-like primary crystals of about 20 µm; intended for further processing before use
PBCHighly abrasive polishing alumina for high cutting
T60/T64 basisSintered aluminas available with grade-specific friability

Process use

GILOX materials suit compound formulations and pre-polishing steps that must remove defects or establish a controlled starting surface for a finer abrasive. The stronger crystal structure maintains cutting action under load.

A practical sequence is to validate cut rate first, then measure the residual scratch pattern and the time required by the following polish. A coarse grade that removes material quickly can still be inefficient if it leaves scratches that extend the next stage.

Qualification checks

POLISHX technical profile · 2026-10-12