POLISHX

P-Series | Almatis

The Almatis P-Series is a family of polishing aluminas whose controlled particle top size balances material removal and surface gloss. P 6 is the coarse, higher-cut grade; P 2 provides intermediate cutting with a finer finish; and P 10 feinst is the very-fine option for low cut and high gloss.

MaterialAlumina
Control characteristicTightly controlled particle top size
P 6Coarse; higher cutting and medium finish
P 2Medium particle-size distribution; some cutting with a finer finish
P 10 feinstVery fine; low cutting and high gloss
Process spanCutting through final gloss
Primary selection trade-offRemoval rate versus finish quality

Cut-to-gloss progression

The P-Series provides a simple progression from coarse cutting to gloss finishing. The key distinction is not the product number alone but the balance between the largest particles, the overall distribution and the surface requirement.

P 6 is the removal-oriented option, P 2 occupies the intermediate stage and P 10 feinst is intended when finish quality and gloss take priority over cut rate.

Grade comparison

P 6Coarse grade; higher cutting with a medium finish
P 2Medium particle-size distribution; moderate cutting with a finer finish
P 10 feinstVery fine grade; low cutting with high gloss

Process planning

Use the coarsest grade only when the incoming defect depth or required stock removal justifies it. For established surfaces, moving directly to P 2 or P 10 feinst can reduce the number of steps and lower the risk of introducing deep scratches.

The carrier, abrasive concentration, pad or tool, pressure and relative speed all influence the observed result. Grade qualification should therefore hold those variables constant while cut rate, haze and gloss are compared.

Control points

POLISHX technical profile ยท 2026-10-12