POLISHX

WEBER MDK double-head panel sanding machine

WEBER MDK is a modular double-head sanding machine for double-sided processing of fibre and panel materials. Its technical configuration covers 1,350, 1,600, 1,900 and 2,250 mm working widths, a 2,620 mm sanding belt and one to three freely arranged sanding stations with D, P and K processing units.

ManufacturerHans WEBER Maschinenfabrik / WEBER America
ModelWEBER MDK
skuWEBER MDK
Machine typeDouble-head panel sanding machine
Working widths1,350 / 1,600 / 1,900 / 2,250 mm
Sanding-belt length2,620 mm
Sanding stations1–3, freely arranged
Calibration-roller driveUp to 110 kW in the technical-specification block
External sanding drivesDescriptive copy states up to 160 kW per drive
Controli-Touch controller and Multi Panel
FeedContinuously variable
Processing unitsD contact roller + P cushion + K combination unit
WorkpiecesFibre and panel materials; veneer and plywood configurations are discussed

Machine specification

The machine is intended for double-sided processing of fibre and panel materials and can be integrated into industrial production lines. External drive frames isolate the sanding drives from the machine body to reduce vibration transfer.

ModelWEBER MDK
Working widths1,350 / 1,600 / 1,900 / 2,250 mm
Sanding-belt length2,620 mm
Sanding stations1–3; arrangement freely selectable
Calibration-roller driveUp to 110 kW in the machine technical-specification block
Controli-Touch controller and Multi Panel
FeedContinuously variable
Processing unitsD contact roller, P cushion and K combination unit

Modular configuration context

Descriptive copy on the page states that the modular column design can support up to eight processing stations, while the technical machine block specifies one to three sanding stations. These statements are retained separately because processing stations in an extended modular line are not necessarily equivalent to the configured sanding-station count.

The introduction also describes external sanding drives up to 160 kW per drive, whereas the machine technical block lists the calibration-roller drive up to 110 kW. Drive power therefore has to be matched to the selected unit and ordered configuration.

Processing-unit roles

The published unit data are series-dependent. Roller diameter, hardness and drive rating vary with the selected station and must not be treated as one fixed MDK-wide value.

D contact rollerCalibration, pre-sanding and fine sanding; grooved steel or rubber roller; programme-controlled grit compensation
P cushion unitGentle finishing of veneer, profiled and coated surfaces
K combination unitContact roller plus sanding beam for calibration followed by fine finishing
D-unit adjustmentElectric roller positioning; calibration stated within a 0.01 mm range
K-unit adjustment0.02 mm adjustment accuracy; synchronous or counter-rotating direction

Production and maintenance boundaries

The freely selectable station arrangement, central machine-parameter control and external drive frames support line-specific configuration. Electronically controlled link pressure beams are described for veneer and plywood sanding-pad stations.

The reviewed page does not provide one overall machine footprint, mass, electrical supply, dust-extraction airflow or finished-panel tolerance. Those installation and acceptance values remain configuration-specific and are not inferred here.

POLISHX technical profile · 2026-10-13 23:40:37