POLISHX

RAPOL-Series | Almatis

The Almatis RAPOL family is formulated for one-step cut and shine on softer surfaces such as automotive paint and resin. RAPOL 100, RAPOL 500 and RAPOL 600 use controlled calcination and particle size to combine an effective cutting action with a polished finish.

MaterialPolishing alumina
Target surfacesSoft surfaces
Example substratesAutomotive paint and resin
Process objectiveCut and shine in one step
Controlled variablesCalcination degree and particle size
GradesRAPOL 100, RAPOL 500, RAPOL 600
Finish objectiveHigh-quality shine with efficient cutting
Process benefitPotential reduction in polishing stages

Soft-surface focus

RAPOL is positioned for surfaces that can be damaged by an overly aggressive abrasive but still require defect removal. The controlled calcination and particle-size design is intended to balance cut with the scratch refinement needed for shine.

Typical examples are automotive coatings and resin surfaces. Because coating hardness and cure state vary, a low-visibility test area should be used before a full production run.

Series grades

RAPOL 100Controlled calcination and particle size for one-step cut and shine
RAPOL 500Controlled calcination and particle size for one-step cut and shine
RAPOL 600Controlled calcination and particle size for one-step cut and shine

One-step process logic

A successful one-step compound must remove the target defect while its scratch pattern breaks down or refines enough to meet the finish requirement. Tool type, carrier, abrasive loading and heat generation determine whether that balance is achieved.

The family page identifies the three grades but does not publish their complete comparative particle data. Grade selection should therefore rely on controlled testing and the product-specific technical data.

Application controls

POLISHX technical profile ยท 2026-10-12