POLISHX

PSG Series | Almatis

The Almatis PSG-Series uses hard, low-surface-area calcined alumina with tightly controlled calcination and particle-size distribution for very heavy cutting and surface preparation. PSG 100 and PSG 200 are both listed with a 200 µm top cut and are intended for high-friction, high-removal polishing compounds.

MaterialHard calcined alumina
Surface areaLow
Particle distributionTightly controlled
PSG 100 top cut200 µm
PSG 200 top cut200 µm
Primary dutyVery heavy cutting compounds
Process characteristicHigh cutting and friction rates
RoleSurface preparation before finer finishing

Heavy-cut abrasive

PSG is designed for robust polishing stages where rapid material removal is required. Its hard calcined structure and low surface area support high friction and cutting action, while particle-size control limits variation between batches.

Both PSG 100 and PSG 200 are described with a 200 µm top cut. Because the public family description does not state every differentiating property, they should not be treated as interchangeable without checking the grade-specific product data.

Published grade facts

PSG 100Calcined alumina; 200 µm top cut; very heavy cutting compound duty
PSG 200Calcined alumina; 200 µm top cut; very heavy cutting compound duty

Where it fits

PSG is a preparation abrasive rather than a final-polish default. It is suited to compounds that must remove pronounced defects or establish geometry before a finer stage.

High friction raises the importance of temperature control, pad condition and lubricant or carrier selection. Excess heat or an overloaded interface can change the cut pattern and make a nominally stable abrasive process inconsistent.

Qualification checks

POLISHX technical profile · 2026-10-12