M-Bond 610 Mixing Instructions
Also listed as: PRODUCT USE INSTRUCTIONS
Refer to the original PDF for tables, figures and page layout.
Page 1\nProduct Guide \nwww.alliedhightech.com \nAllied High Tech Products, Inc. \nCall for more information: 800.675.1118 \nM-Bond 610 2-Component System\nDate: 10/2020, v1.3\nRefer to the SDS document for additional safety information. \nM-Bond 610 is a permanent, 2-component epoxy phenolic adhesive that cures in 1 hour at\n150 °C (302 °F). It is chemically resistant, provides a very thin glue line and will not outgas \nunder vacuum. It is commonly used to bond multiple samples together and to adhere thinned \nsamples to grids for TEM or FIB observation.\nDO NOT open a resin or curing agent bottle before it has reached room temperature! \nInstructions \n1. Using the included disposable plastic funnel, empty\nthe contents of the bottle labeled "Curing Agent" into\nthe bottle labeled "Adhesive." Discard the funnel\nwhen finished.\n2. Use the included brush applicator cap to securely\nclose the "Adhesive" bottle and thoroughly mix the\ncontents by vigorously shaking it for 10 seconds.\n3. Mark the bottle in the space provided on the label\nwith the mixing date. Allow the freshly mixed\nadhesive to stand for at least 1 hour before using.\nCuring must begin within 4 hours of application.\nStorage \nKeep the containers closed \nwhen not in use. Do not store \nabove 48 °C (120 °F). The \nshelf life is 9 months from \ndate of manufacture when \nstored at room temperature \n(24°C; 75°F) or 15 months \nfrom date of manufacture \nwhen refrigerated (5°C; 40°F), \nwhich is recommended. \nTechnical Information \nMixing Ratio (by weight) \n1:1 (Resin: Curing Agent) \nCuring Schedule \n1 hour at 150 °C (302 °F) \n2.5 hours at 120 °C (248 °F) \n4 hours at 100 °C (212 °F) \nOperating \nTemperature Range \nShort Term \n-452° to +700°F (-269° to +370 °C)\nLong Term \n-452° to +500°F (-269° to +260 °C)\nTransducers \nto +450°F (+230 °C) \nPot Life \n6 Weeks \nat 24 °C (75 °F) \n12 Weeks \n40 °F (5 °C) \nElongation Capabilities \n1% at -452 °F (-269 °C) \n3% at +76 °F (+24 °C) \n3% at +500 °F (+260 °C) \nClamping Pressure \n10 to 70 psi (70 to 480 kN/m2); \n30 to 40 psi optimum (200 to 275 kN/m2) \nRecommended Postcure \n2 hours at 50°–75°F (30°–40°C) above maximum operating \ntemperature or cure temperature, whichever is higher \nHigh Precision Transducer Postcure \n2 hours at 400°–450°F (205°–230°C) after wiring \nGHS07 \nGHS05 \nGHS08 \nGHS02 \nGHS09 \n