MOUNTING WAX DISSOLVER PRODUCT USE INSTRUCTIONS
Refer to the original PDF for tables, figures and page layout.
Page 1\n \n \nProduct Guide \nwww.alliedhightech.com \nAllied High Tech Products, Inc. \nCall for more information: 800.675.1118 \nWax Dissolver \nDate: 10/2020, v1.1\nRefer to the SDS document for additional safety information. \n \n \nWax Dissolver (#71-10210) is a solvent used to remove sheet wax (#71-10400) from fixtures \nand samples. It should be stored at room temperature. \n \nInstructions \n \n1. Place the sample and fixture on a hot plate and reheat the wax. Once the wax is soft, \nremove the sample. \n \n2. Use a cotton-tipped applicator to apply the Wax Dissolver directly to the wax remaining on \nthe sample and/or fixture by rolling the tip over the wax. If too much wax builds up on the \napplicator, discard it and continue with a new one. A lint free wipe or paper towel can also \nbe used. \nNote: Using the wax dissolver while the fixture is still on the hot plate can make wax \nremoval slightly faster. \n \n3. Clean the sample in water, isopropyl alcohol or acetone to remove any residual Wax \nDissolver. \n \nTechnical Information \nOdor \nCitrusy \nColor \nClear \nSolubility \nNot Miscible in Water \nSpecific Gravity \n0.843 \nBoiling Point \n173 °C (343.4 °F) \nFlash Point \n50 °C (122 °F) \nIgnition Point \n255 °C (491 °F) \nVapor Pressure at \n50 °C (122 °F) \n50.66 hPa (38 mm/Hg) \nVapor Density \n4.7 (Relative to Air = 1) \n \nGHS02 \nGHS07 \nGHS09 \n