{
  "title": "Coated abrasive and non-woven combi rollers for burnishing machines | EUGMFR001 | Osborn GmbH",
  "kind": "reference",
  "company": "Osborn",
  "category": "Nonwoven abrasives & brushes",
  "parameters": {},
  "summary": "EUGMFR001 combines aluminium-oxide coated abrasive cloth with non-woven material in a burnishing roller. The hybrid construction is used to remove small scratches, refine the pattern and prepare a surface for a subsequent satin-finishing stage.",
  "sections": [
    {
      "heading": "Hybrid construction",
      "paragraphs": [
        "Abrasive-cloth flaps and non-woven elements are combined in one industrial finishing roller. The coated abrasive provides cutting action while the non-woven component refines the emerging pattern.",
        "The abrasive specified for the documented variants is aluminium oxide."
      ]
    },
    {
      "heading": "Intended operation",
      "paragraphs": [
        "The roller is intended for burnishing machines and preparation before satin finishing. It is described for fine surface patterns and removal of small scratches.",
        "It should be treated as a preparation tool: final appearance depends on the following finishing stage, grade sequence and workpiece direction."
      ]
    },
    {
      "heading": "Documented configuration",
      "paragraphs": [
        "One documented variant uses grit 60, a 19 mm arbor hole, 100 mm diameter and 100 mm face width. Its listed maximum speed is 5,700 rpm.",
        "A grit 120 variant is also present in the family, allowing a finer preparation step with the same general roller concept."
      ]
    },
    {
      "heading": "Setup guidance",
      "paragraphs": [
        "Match bore and dimensions to the machine spindle and guard. Establish feed, overlap and contact pressure on test material before processing visible parts.",
        "Do not exceed the marked speed. Replace a roller with damaged flaps, uneven wear or an insecure bore fit."
      ]
    }
  ],
  "updated_at": "2026-10-11 19:44:50"
}