{
  "title": "Microclear Ultra Aluminum Oxide Polishing Powder Series",
  "kind": "reference",
  "company": "Micro Abrasives Corporation",
  "category": "Abrasive grains & powders",
  "parameters": {
    "Series": "Microclear Ultra",
    "Material": "Aluminum oxide polishing powder",
    "Available grades": "Ultra .5, .75, 1, 2, 4, 6, 8 and 12",
    "Typical pH": "9.2",
    "Typical alpha alumina": "50–80%"
  },
  "summary": "Microclear Ultra is a dewatered aluminum oxide polishing powder family produced after wet milling. The series offers multiple nominal size grades for balancing stock removal and finish, with typical pH 9.2 and alpha-alumina content of 50–80%.",
  "sections": [
    {
      "heading": "Material architecture",
      "paragraphs": [
        "The Ultra series is wet milled to establish its particle-size distribution and then dewatered to create a powder suitable for formulation. It uses the same core preparation route as the Microclear DS slurry family but is supplied dry.",
        "The series is positioned to combine stock removal with final surface quality. Standard surface-area material is the normal offering; a high-BET version may be available by request."
      ]
    },
    {
      "heading": "Typical physical properties",
      "rows": [
        [
          "Appearance",
          "White powder"
        ],
        [
          "Ultra .5 average particle size",
          "Greater than 1 µm, as listed"
        ],
        [
          "Ultra 1 average particle size",
          "Less than 2 µm, as listed"
        ],
        [
          "Ultra 2 average particle size",
          "2.3 µm"
        ],
        [
          "Ultra 6 average particle size",
          "6 µm"
        ],
        [
          "Ultra 8 average particle size",
          "8 µm"
        ],
        [
          "Ultra 10/12 average particle size",
          "10 µm"
        ],
        [
          "pH",
          "9.2"
        ],
        [
          "Alpha alumina",
          "50–80%"
        ]
      ]
    },
    {
      "heading": "Applications and grade selection",
      "paragraphs": [
        "Listed substrates include automotive clear coats, marine surfaces, chrome, aluminium and stainless steel. Coarser grades generally provide a different cut-to-finish balance than finer grades, but the final response depends on formulation and process conditions.",
        "Ultra .5, .75, 1, 2, 4, 6, 8 and 12 are series grade names. Do not substitute the grade number directly for a guaranteed particle-size limit; use the listed typical property for the chosen grade."
      ]
    },
    {
      "heading": "Handling and qualification",
      "paragraphs": [
        "Typical values are guidance rather than release specifications. Confirm the required particle-size distribution, surface area and alpha-alumina content for the intended formulation. Control dust during powder handling and validate dispersion, removal rate, finish and residue on representative substrates."
      ]
    }
  ],
  "updated_at": "2026-10-12 19:32:12"
}