Electer Evolution
Electer Evolution is a portable mechanical preparation unit for in-situ grinding and polishing before chemical etching, electrolytic polishing or electrolytic etching. It combines a transport case, control panel, reversible electronic speed control and two motor connections with a 1:4 reduction drive and 90° bevel tool holder.
Technical specifications
| Manufacturer / publisher | PRESI |
|---|---|
| Reference | 58100 |
| Application | Portable in-situ mechanical grinding and polishing |
| Motor speed | 1,500–25,000 rpm |
| Reducer | 1:4; increases power by factor 4 |
| Motor outlets | 2 |
| Rotation | Reversible |
| Tool holder | 90° bevel gear |
| Supply voltage | 220 V |
| Category | Chemical & special polishing |
| Updated | 2026-10-14 |
Preparation role
The unit is designed to prepare a local surface without removing the workpiece from its installation. It supports mechanical grinding and polishing before chemical etching or before an electrolytic polishing or etching stage.
A portable case protects the equipment during transport. The control panel provides electronic speed adjustment and rotation-direction selection for the connected motor.
Drive and connection data
| Motor speed range | 1,500 to 25,000 rpm |
|---|---|
| Motor connections | Two outlets |
| Rotation direction | Selectable forward or reverse |
| Reduction drive | 1:4 ratio; stated to increase available power fourfold |
| Tool orientation | Tool holder with 90° bevel gear |
| Electrical supply | 220 V |
| Conformity statement | Built in accordance with EC standards |
Operating workflow
Choose the abrasive sequence and tool for the material, required removal rate and final etching method. Establish the local working area, connect the selected motor, confirm the direction of rotation and begin at a controlled speed.
Progress from grinding to finer polishing while preventing cross-contamination between abrasive stages. The 90° holder supports access where a straight tool axis would be awkward; the reduction drive is appropriate when additional torque is required.
Maintenance and safety
Inspect the cable, motor connection, reducer and tool holder before use. Secure the work area and verify that the mounted abrasive is rated for the selected rotational speed.
Stop and isolate the 220 V supply before changing tools or servicing the drive. Wear eye and face protection and manage debris at the point of work; follow the chemical controls required for any later etching operation.