Struers methods: Polyethylene Pe Soft And Ductile 1505 Dp Susp Plub. Source classification: Polymers.
Searchable text transcription
The page images and original PDF preserve the table layout and notation.
Polyethylene [PE] - Soft and ductile 1505 Polymers DP-Susp. P/Lub. Polishing Steps DP DP 2 OP Surface Type MD-Mol MD-Nap MD-Chem Disc speed (rpm) 150 150 150 Abrasive Type DP-Susp. P 3 µm DP-Susp. P 1 µm OP-S, 0.25 µm Predosing/dosing 3/6 3/6 1/10 Lubricant Type DP-Red DP-Red Predosing/dosing 3/12 3/14 Force (N) 30 20 10 Holder direction >> >> >< Holder speed (rpm) 150 150 150 Time (min) 4 3 1 Grinding Steps PG FG FG 2 FG 3 Surface Type SiC Foil #220 SiC Foil #500 SiC Foil #1200 SiC Foil #4000 Disc speed (rpm) 300 300 300 300 Abrasive Type Predosing/dosing 0/0 0/0 0/0 0/0 Lubricant Type Water Water Water Water Predosing/dosing 0/0 0/0 0/0 0/0 Force (N) 20 20 20 20 Holder direction >> >> >> >> Holder speed (rpm) 150 150 150 150 Time (min) 1 1 1 1 The method is developed to fit a standard equipment configuration with 30 mm specimen on 300mm disc. Dosing levels are valid for following equipment: Tegramin, AbraPol and LaboPol For advice on how to adjust the method to fit your equipment, please take a look at Preparation Parameters. The preparation time for the plane grinding (PG) step depends very much on the condition of the samples and if they are prepared as single specimens or clamped in a specimen holder. Please check the samples after the first step and repeat it if necessary. Method comments Take a look at Preparation Parameters