Wheel brushes for table-deburring machines, abrasive filament | EUPBWB026 | Osborn GmbH
EUPBWB026 is an abrasive-filament wheel brush for table deburrers and automated edge-finishing machines. Dense silicon-carbide filaments provide a controlled abrasive action on pipes, profiles and flat parts while the statically balanced body supports stable production running.
Technical profile
| Manufacturer / publisher | Osborn |
|---|---|
| Category | Industrial grinding & sanding |
| Updated | 2026-10-11 20:34:55 |
Abrasive-filament process
Unlike metallic wire brushes, the trim contains abrasive filament that cuts through distributed abrasive grains. The dense construction supports deburring and smoothing while conforming to component edges.
The family is listed for aluminium, stainless steel and steel across defined burr classes.
Machine compatibility
The brush is intended for mounting on table deburrers and automated machines. Regular bores, keyway interfaces and special adapters support different spindle arrangements.
Static balancing and concentricity control are important because the wheel operates as a wide production tool rather than a handheld accessory.
Documented configuration
One documented variant uses silicon-carbide filament in grit 120 with a filament diameter of 1.02 mm. Wheel diameter is 250 mm, face width 60 mm and trim length 45 mm.
The cited interface is a 50.8 mm bore with keyways; maximum speed is 3,600 rpm and the displayed SKU is 1232-576916.
Process control
Select grit and filament diameter around burr size, substrate and the required edge radius. Excess immersion can increase heat and filament fatigue without improving finish.
Confirm bore, key engagement, guard clearance and rotation before use. Establish feed and penetration on test parts and monitor wheel wear for consistent edge quality.