Wheelblast wear-parts selection and compatibility guide
Wheelblast spare-part selection depends on the exact turbine, rotation and machine build. This guide identifies the main wear components and the legacy equipment families covered by the support range, then sets out a verification workflow that reduces wrong-part orders and unplanned downtime.
Technical profile
| Manufacturer / publisher | Wheelabrator |
|---|---|
| Typical parts | Blades; control cages; impellers; tune-up kits; wheel hubs; feed spouts |
| Coverage | Wheelabrator product lines; selected non-Wheelabrator high-wear parts |
| Legacy families | BCP; Gutmann; Spencer Halstead; BMD; Schlick; Tilghman; DISA; Sisson Lehmann; Georg Fischer |
| Category | Mass finishing & blasting systems |
| Updated | 2026-10-14 |
Common wear components
| Blades | Accelerate abrasive; geometry, material and rotation must match the wheel. |
|---|---|
| Control cage | Controls the abrasive entry position and blast pattern. |
| Impeller | Meters and directs abrasive into the blade path. |
| Tune-up kit | Coordinated set of wear components intended for a defined wheel service. |
| Wheel hub | Supports the rotating assembly and must match the wheel design. |
| Feed spout | Carries abrasive into the impeller and wheel inlet. |
Supported equipment scope
The parts range covers Wheelabrator product lines and selected high-wear parts for non-Wheelabrator equipment. Legacy names listed in the support portfolio include BCP, Gutmann, Spencer Halstead, BMD, Schlick, Tilghman, DISA, Sisson Lehmann and Georg Fischer.
A legacy brand name is not sufficient for part selection because machines may have been rebuilt or fitted with later wheels. Use the current installed assembly as the final reference.
Identification workflow
Capture the nameplate, machine serial number, turbine model, wheel diameter, clockwise or counter-clockwise rotation, drive arrangement and clear images of the installed parts. Record casting or part numbers where legible.
Compare blade count, control-cage opening, impeller dimensions, hub interface and feed-spout geometry. Treat tune-up kits as configuration-specific; do not combine visually similar parts from unrelated wheel families.
Stocking and safe replacement
Classify critical spares by wear rate, procurement lead time and the production consequence of failure. Coordinated sets can reduce the risk of mixing wear levels that affect balance or blast distribution.
Before replacement, isolate all energy and remove abrasive from the work zone as required. Inspect adjacent liners and fasteners, verify correct rotation and retention, then test the blast pattern and surface result under controlled conditions.