P-Series | Almatis
The Almatis P-Series is a family of polishing aluminas whose controlled particle top size balances material removal and surface gloss. P 6 is the coarse, higher-cut grade; P 2 provides intermediate cutting with a finer finish; and P 10 feinst is the very-fine option for low cut and high gloss.
Technical profile
| Manufacturer / publisher | Almatis |
|---|---|
| Category | Abrasive grains & powders |
| Updated | 2026-10-12 |
Cut-to-gloss progression
The P-Series provides a simple progression from coarse cutting to gloss finishing. The key distinction is not the product number alone but the balance between the largest particles, the overall distribution and the surface requirement.
P 6 is the removal-oriented option, P 2 occupies the intermediate stage and P 10 feinst is intended when finish quality and gloss take priority over cut rate.
Grade comparison
| P 6 | Coarse grade; higher cutting with a medium finish |
|---|---|
| P 2 | Medium particle-size distribution; moderate cutting with a finer finish |
| P 10 feinst | Very fine grade; low cutting with high gloss |
Process planning
Use the coarsest grade only when the incoming defect depth or required stock removal justifies it. For established surfaces, moving directly to P 2 or P 10 feinst can reduce the number of steps and lower the risk of introducing deep scratches.
The carrier, abrasive concentration, pad or tool, pressure and relative speed all influence the observed result. Grade qualification should therefore hold those variables constant while cut rate, haze and gloss are compared.
Control points
- Prevent cross-contamination between coarse and fine stages.
- Measure the incoming and final surface rather than judging gloss alone.
- Keep mixing ratio and dwell time fixed during comparative trials.
- Use dust control and the relevant handling information for dry alumina powder.