Apparecchiature per la Preparazione elettrolitica

Workflow selection

LectroPol-7 suits laboratory preparation where stored methods, voltage scanning and controlled electrolyte conditions are required. MoviPol-5 addresses large structures, welds and other surfaces that must be prepared in place. TenuPol-5 is dedicated to electrolytic pre-thinning and final thinning of small TEM discs.

Method capacity and repeatability

• LectroPol-7 provides more than 10 supplied methods and stores up to 200 custom methods.
• MoviPol-5 stores up to 20 methods for repeatable field routines.
• TenuPol-5 includes 18 supplied methods—eight for pre-thinning and ten for final thinning—and stores up to 200 user methods.

Specimen and access constraints

LectroPol-7 separates the control and polishing units with a 2 m cable; an optional arm accommodates specimens up to 100 mm high. MoviPol-5 uses a polishing pistol, exchangeable electrolyte cartridge and peristaltic pump so horizontal or inverted surfaces can be reached. TenuPol-5 accepts 12–21 mm starting material for pre-thinning and produces 3.0 mm or 2.3 mm final discs.

Power, endpoint and process monitoring

MoviPol-5 can run from a rechargeable battery for up to 1.5 hours or from mains power. LectroPol-7 monitors electrolyte temperature, current and voltage. TenuPol-5 uses infrared perforation detection to stop final thinning at the selected light-stop value.

Application boundary

These systems share an electrolytic preparation principle but are not interchangeable SKUs. Selection depends on whether the work is controlled laboratory polishing and etching, portable surface preparation, or TEM specimen thinning. Electrolyte compatibility, ventilation and the applicable operating procedure must be confirmed for the selected method.

Files & downloads