Rotary Mesh Table (RMT) | Wheelabrator
The Rotary Mesh Table (RMT) is a compact pass-through wheelblast machine for cut, machined and small cast components. Four TITAN wheels blast from above and below the mesh conveyor, enabling full surface treatment in one cycle while loading and unloading remain on the same side.
Technical profile
| Manufacturer / publisher | Wheelabrator |
|---|---|
| Category | Mass finishing & blasting systems |
| Updated | 2026-10-11 20:32:35 |
Process layout
Parts travel on a rotating mesh table through blast streams arranged above and below the belt. The documented layout uses four TITAN 14.3 wheels, each rated at 7.5 kW.
The wheel arrangement is intended to cover multiple faces in a single pass and avoid a separate turn-over operation.
Workpiece and load limits
The maximum documented part envelope is 400 × 400 × 300 mm and the maximum single-part mass is 20 kg. Total conveyor load is listed at 500 kg.
These limits must be checked together: a small but dense part can meet the dimensional envelope while exceeding the individual load allowance.
Throughput and installation
Pass-through speed is variable up to 4.5 m/min, allowing exposure time to be matched to rust removal, cosmetic blasting or surface-preparation duty.
Loading height is 850 mm. The machine footprint is approximately 3.2 × 2.8 m, requires no foundation pit and is delivered fully assembled for plug-and-play setup.
Engineering checkpoints
Mechanical pre-acceleration produces an abrasive velocity of about 60 m/s. The cited total connected load is 42 kW and overall height is 5,150 mm.
Validate media, part stability, mesh support, dust extraction and target finish on representative components before fixing conveyor speed.