Coated abrasive and non-woven combi rollers for burnishing machines | EUGMFR001 | Osborn GmbH
EUGMFR001 combines aluminium-oxide coated abrasive cloth with non-woven material in a burnishing roller. The hybrid construction is used to remove small scratches, refine the pattern and prepare a surface for a subsequent satin-finishing stage.
Technical profile
| Manufacturer / publisher | Osborn |
|---|---|
| Category | Nonwoven abrasives & brushes |
| Updated | 2026-10-11 19:44:50 |
Hybrid construction
Abrasive-cloth flaps and non-woven elements are combined in one industrial finishing roller. The coated abrasive provides cutting action while the non-woven component refines the emerging pattern.
The abrasive specified for the documented variants is aluminium oxide.
Intended operation
The roller is intended for burnishing machines and preparation before satin finishing. It is described for fine surface patterns and removal of small scratches.
It should be treated as a preparation tool: final appearance depends on the following finishing stage, grade sequence and workpiece direction.
Documented configuration
One documented variant uses grit 60, a 19 mm arbor hole, 100 mm diameter and 100 mm face width. Its listed maximum speed is 5,700 rpm.
A grit 120 variant is also present in the family, allowing a finer preparation step with the same general roller concept.
Setup guidance
Match bore and dimensions to the machine spindle and guard. Establish feed, overlap and contact pressure on test material before processing visible parts.
Do not exceed the marked speed. Replace a roller with damaged flaps, uneven wear or an insecure bore fit.